Attach the brackets then place the device where you want it.
Frontpoint control panel wall mount.
They run on a 100 cellular connection with a built in wi fi backup.
Once the control panel is fully armed and a door sensor is tripped the control panel will beep for 30 seconds.
Every frontpoint system uses the frontpoint hub and keypad as the central command center.
Before mounting the panel to a wall.
The hub is the brains of your alarm system and the keypad is how you control it.
Test opening the door from frontpoint app again.
Remove the triangular shaped tabletop stand to expose all needed screw holes.
Make sure the sensor is mounted with the arrow pointed towards the ceiling.
Www frontpoint com help control panel it all starts here.
All frontpoint systems come with a wall mounted or tabletop controller that serves as your primary interface.
Unprecedented control is just steps away.
The touchscreen control panel has desktop setup and wall mounting options.
Here you ll find everything you need to set up and get familiar with your frontpoint system.
For a wall mount setup the touchscreen comes with wall mounting bracket and screws.
Every frontpoint system uses the frontpoint hub and keypad as the central command center.
Use the appropriate screws not included to mount the base plate to the wall remount the panel onto the hinge and close the panel.
You can arm and disarm the system from the panel check the weather view sensor status.
From the frontpoint app test opening the door with the tilt sensor mounted.
There are no phonelines to cut the system is.
Get your system up and running starting with your control panel.
Keep note of the red battery wires and ac wires both should be going out through an oval or square hole on the back plate.
Move the control panel to final location and send rediscover network signal.
Touch screen control panel.
This countdown is called the entry delay which is the amount of time you have when entering the home to disarm the system by entering your 4 digit code into the control panel.
Close the door and mount tilt sensor on the door.
The control panel serves as the nerve center for your system.
The hub and keypad are pre programmed and ready to connect to your network and devices right out of the box.
Yes your control panel can be mounted on a flat wall surface using size appropriate screws.
The screws are not provided with the panel itself and must be acquired by going to your local hardware store.
The hub is the brains of your alarm system and the keypad is how you control it.
Www frontpoint com help a b c do not mount sensor directly on a window glass break sensor.
